Agriculture irrigation pipe

Agriculture irrigation pipe

Specification
Diameter:16mm
Material:PE
Wall thickness:0.5mm,0.6mm,0.7mm0.8mm,0.9mm,1.0mm,1.1mm,1.2mm  or according to customer's request
Drip spacing:10cm,20cm,30cm,40cm,50cm to 200cm or according to customer's request.
Pressure:1-3 bar
Flow rate:2L/H,3L/H,4L/H

Agriculture irrigation pipe

Advantages
1. The labyrinth flow path is long, ensuring that the water dripping is stable.
2. High water pressure and long flow path enable the turbulent flow inside the emitters so that the emitters can wash themselves continuously.
3. The filter square of water dripping entrance is big then the anti-blocking capacity is strengthened.
4. There can be one,two or four water dripping outlets on each emitter, which greatly lowers the risk of water interception due to the outside blocking.
5. The mosaic whole type emitter has been installed before it's taken out from factory, which reduces the emitter installation fee and lowers the cost.
6. The paving length can reach up to 100m.
7. It's firm and can be used in all seasons.
8. Compared with common drip irrigation tape, it has stronger environment adaptability, better anti-blocking capacity, fewer requirements for water quality, more stable water dripping and longer service life( The service life of irrigation tape is 3-5years normally);
9. It's more suitable for economic crops, greenhouse, garden,greening project, desert improving,full-buried type irrigation etc. The distance between emitters can be adjusted according to the actual needs.

This article comes from http://www.tongdapvcpipe.com/